How To: Lights On Reminder

By: GEO

DISCLAIMER : TeamSol of Washington or persons submitting the information here will not assume responsibility, nor be held liable for damage resulting from the use or misuse of any information contained on this page. In other words, any information you find here is used at your own risk.
Tools need : Soldering Iron, solder, wire cutters

Here are the parts needed, bought from the local NAPA store.

You can leave the alligator clips on, but for a cleaner, safer look you may want to cut them off and solder the wires on the flat clips for the fuses used in our cars. (See below photo).

With the clips now solder on it is ready to be installed in the car (see above photo) Now for the install: Pull the fuse and wrap/slide the clip on the fuse towards the bottom side and put back in, you may have to cut part of the clip off at the bottom to install the fuse back in. The fuses to connect to are: Wiper, Washer (P/W RLY) (20A) and Tail Light, Instrument Light, License Light (10A). See photo below. You can cut a small piece of the double back tape and hang the buzzer from the bottom of the fuse box as we did here.

Now your done...Enjoy no more lights left on...

By: GEO