How To: Aux Light Mod

DISCLAIMER : TeamSol of Washington or persons submitting the information here will not assume responsibility, nor be held liable for damage resulting from the use or misuse of any information contained on this page. In other words, any information you find here is used at your own risk.

With this Mod you will have total control over your running lights
Tools need : Soldering Iron, solder, wire cutters, phillips screw driver

Here are the parts needed for the project:
Wire connectors, fuse link, fuse, wire, electrical tape and shrink tubing

Two screws need to be taken out to access the intrument panel,
after taking them out pull the panel out to access the wiring.

Now you can see the connector for the Aux lights, the green one

Now with the connector pulled you can access the wire you need to cut,
the wire on my car is the red one with a white stripe on it, the one on the
right side of the connector

Here the wiring connector are on with a 2 foot piece of wire added
with a fuse link added on the bottom that plugs into the fuse box.
Also note I added a connector to the old power wire so I can put
every thing back to stock if I want. The old power wire was taped
with electrical tape so it doesn't short out before I put the panel
back in. Now I found a plug-in on the fuse box that only comes on
when the car is running so it turns on when you start the car and
goes off when you turn the car off, you can also turn the running
lights off if you wish not to use them.

After doing this your car will be like the Del Sols from Canada that
have the running lights on at all times. Enjoy the mod.

Author Geo